bing tracking image

Filter Questions and Answers:

reset filter

Expert Answers about Hyundai Santa Fe


  • What Does Curt Trailer Hitch # C12923 Weigh
  • The Curt hitch part # C12923 weighs 33 lbs total and has a capacity of 3,500 lbs trailer weight and 350 lb tongue weight.
    view full answer...

  • How Much Can a 2017 Hyundai Santa Fe Tow with Curt Trailer Hitch Receiver
  • The Curt Trailer Hitch Receiver part # C13152 is rated for up to 6,000 lbs. However, your 2017 Hyundai Santa Fe is only rated for 2,000 lbs unless you have the factory tow package then you are rated for up to 5,000 lbs. The lower of the two ratings (hitch/vehicle) will need to be the limit you abide by. Please also note if the trailer is over 1,653 lbs it will need to have brakes according to the owner's manual. I have attached some other parts you will need below. Curt T-Connector Vehicle...
    view full answer...

  • Can a 2012 Hyundai Santa Fe Tow a Horse Trailer
  • Your friend will first to consult the vehicle owners manual of his 2012 Hyundai Santa Fe to see what the towing capacity is for his specific model. If the towing capacity of the vehicle and the trailer hitch used exceed the gross trailer weight then the Santa Fe would be able to tow the trailer. The Curt trailer hitch # C13073 is rated for 350 pounds tongue weight and 3,500 pounds gross trailer weight. Given the average weight of a horse this probably means that only one horse could be...
    view full answer...

  • Distance from Center of Pin Hole to Weld Gusset of Curt Ball Mount part # C45100
  • The distance from the center of the hitch pin hole of the Curt Ball Mount part # C45100 that you referenced to the weld gusset is 4-1/2 inches. I went out into our warehouse and pulled one to get this measurement.
    view full answer...

  • Distance from Hitch Pin Hole to Weld Gusset on Curt Ball Mount # C45090
  • On the Curt Ball Mount # C45090 the distance from the center of the hitch pin hole to the near edge of the reinforcing gusset is 3-inches. From the hole center to the end of the shank the measure is 2-1/2-inches. I prepared a photo diagram for you to show these dimensions. I also linked our main page for all 2-inch ball mounts.
    view full answer...

  • What is the Weight Capacity of Westin E-Series Tube Steps for a 2012 Hyundai Santa Fe
  • The Westin E-Series tube steps, # 23-3425, have a weight capacity of 300 pounds. Though the bars themselves may be capable of more weight, the mounting hardware and locations on the vehicle limit the capacity.
    view full answer...

  • Does The Curt 40K Lunette Ring Have A Max Tongue Weight Limit
  • Lunette rings like the Curt SecureLatch Lunette Ring - Adjustable Channel Mount - 3" Diameter - 40,000 lbs # CU99FR do not have tongue or vertical weight limits. These types of rings are designed for heavy duty situations and loads and are not rated the same way you would a standard ball mount or trailer hitch. You are only limited to the capacity of the tow vehicle and the trailer you are attaching the lunette to. So make sure you double check the load ranges of your owners manual and...
    view full answer...

  • Can One Set of Hydraulic Drum Brakes Provide Enough Stopping Power for a Tandem Axle Boat Trailer
  • If your boat trailer came equipped with hydraulic drum brakes on both axles, it is best to keep both sets in working order, but if this is the route you prefer you'll want to put the new brakes on the rear axle where most of the boat's weight will be concentrated. I linked our main page for hydraulic drum brakes. You can use the filters on the page to select your overall axle capacity (both of your current axles' capacities added together) to see if we have brakes of the appropriate rating,...
    view full answer...

  • Reciever Hitch for my 2020 Somerset E3 Deck Pop Up Camper.
  • The Curt Adjustable Width Trailer Hitch Receiver for part # 13703 is rated for 350 lbs. of toungue weight and 3500 lbs. of gross trailer weight. In your situation you would be well below the stated maximums and using the bolts to install the hitch to your frame would be perfectly acceptable. Of course please check with your camper's manufacturer to ensure that your camper is rated for towing once you have found that you do not want to exceed the lowest weight rating of the camper, hitch...
    view full answer...

  • Determining Hitch Capacity of 2016 Hyundai Santa Fe
  • I can help you determine if the custom fit Curt hitch # C13152 will work for your wheelchair and wheelchair carrier on your 2016 Hyundai Santa Fe. The tongue weight capacity, or maximum downward force that can be safely applied to a hitch is typically 10 percent of the towing capacity of the vehicle. The combined weight of your wheelchair plus the wheelchair carrier, is within the 900lb tongue weight capacity of the hitch itself, but if the tongue weight capacity of your vehicle is less,...
    view full answer...

  • Hitch Fits and Towing Capacity of 2014 Hyundai Santa Fe
  • The towing capacity of the 2014 Hyundai Santa Fe varies depending on the specific engine and transmission in the car and on whether or not the trailer has brakes. Minimum capacity is 1653-lbs for trailers without brakes and the maximum for the manual transmission towing a trailer with brakes is 5512-lbs. Page 5-98 of the online owner's manual indicates this in a chart that I linked for you. If you need a hitch you can use # 75776 if you have the GLS or Limited model, or # 75772 if you...
    view full answer...

  • What is the Speed Rating for the Yakima Rack and Roll Trailer Tires
  • The tires for the Yakima Rack and Roll Trailer like the Replacement Tire for Wheel on Yakima Rack and Roll Trailers # Y8880282 are rated for 94 mph, although to be honest I'm not sure that's a speed I'd be comfortable testing...
    view full answer...

  • Curt Class III Trailer Hitch Dimensions for a 2012 Hyundai Santa Fe
  • The overall dimensions of the Curt Trailer Hitch Receiver # C13073 for your 2012 Hyundai Santa Fe are 54" wide x 11" tall (drop) x 15-3/4" deep. Attached is a photo showing this. Since this is a custom fit application for your vehicle it will match up with the mounting holes in the frame of your vehicle. It hugs the bumper on a Santa Fe really well and when we installed this on a 2012 model we found the hitch height to be 15" - this is measured from the ground to the top inside of the...
    view full answer...

  • Distance from Hitch Pin Hole to Carrier Rail when etrailer Cargo Carrier e98874 is Folded Up
  • When the etrailer Cargo carrier part # e98874 is folded up there is a distance of 9-1/2 inches from the center of the hitch pin hole to the nearest rail of the carrier. You would need to measure from the pin hole on your hitch out to the furthest point on your bumper to see if this would clear. If that distance is less than 9-1/2 inches you would have clearance. When we installed the # 75776 on a 2016 Santa Fe we found it had 4-1/4 inches from the pin hole to the furthest point out on...
    view full answer...

  • Recommended 7-Way Wiring Harness for a 2022 Hyundai Santa Fe
  • Yes, we do. To add a wiring harness to your 2022 Hyundai Santa Fe you will want the Tekonsha OEM Replacement Vehicle Wiring Harness w Brake Controller Adapter item # TK44ZR. This 7-way harness plugs in behind the driver's side rear wheel under the lower fascia. I have attached a picture below to help you find it. The Tekonsha item # TK44ZR also includes a brake controller adapter that works with any Tekonsha brake controller like the item # 90195.
    view full answer...

  • What Size Tap Is Needed To Chase Threads 2012 Hyundai Santa Fe When Installing Curt Trailer Hitch?
  • The Curt Trailer Hitch Receiver # C13073 uses M10 - 1.25 bolts to mount in the factory weld-nuts on the frame of your 2012 Hyundai Santa Fe. Our Metric Tap and Die Set # PT43FR will have this size tap included so you can chase your weld nuts. Do be sure to use some oil on the tap to help it clear the threads.
    view full answer...

  • Recommended 7-Way Wiring Harness for a Curt Echo Wireless Brake Controller
  • You sure can! However, since you're going to use a Curt Echo item # C51180, I recommend using the 7-Way RV Upgrade Kit for Trailer Brake Controller Installation item # ETBC7L instead. Same style of connector but it doesn't include the blue brake controller wire you won't need with the Curt Echo item # C51180. The Universal Installation Kit for Trailer Brake Controller item # ETBC7 will work with a Curt Echo item # C51180 but it is designed for a traditional in cab brake controller which...
    view full answer...

  • Can the Draw-Tite Max-Frame Trailer Hitch Receiver # 75684 Tow a 1,900 lb Boat Trailer
  • The Draw-Tite Max-Frame Trailer Hitch Receiver # 75684, which fits your 2012 Hyundai Santa Fe if it doesn't have the dual exhaust, is a Class III trailer hitch with a 2" receiver. Since the Gross Trailer Weight (GTW) is 3,500 lbs and the Tongue Weight (TW) is 350 lbs it can easily tow your bass boat trailer that weighs about 1,900 lbs. You do need to check the weight rating of your Santa Fe in your owner's manual as the trailer weight rating can range from 2,000 lbs - 3,500 lbs. If your...
    view full answer...

  • Ground Clearance Measurement on 2017 Hyundai Santa Fe Sport with Curt Class III Trailer Hitch
  • When we installed the Curt Class III Trailer Hitch Receiver # C13152 that you referenced on a 2016 Hyundai Santa Fe Sport, we found the inside top of the receiver to the ground measured 13 inches. I've attached a photo showing this measurement for you. For the vehicle we installed the hitch on, from the bottom of the hitch receiver to the ground would measure 10-1/2 inches. These measurements will help give you a good idea of how far off the ground your hitch receiver will sit. I can't...
    view full answer...

  • Weight capacity of the Yakima RidgeBack 4-Bike Rack
  • I checked with Yakima and the Yakima RidgeBack 4-Bike Rack # Y02458 that you referenced has a 150 lb total capacity with a max of 40 lbs per bike cradle. I attached a review video for you to check out also. If you plan on carrying any womens or alternative framed bikes without horizontal top tubes you may also be interested in purchasing a Swagman Easy-Out Women's and Alternative Frame Bike Adapter # 64005 to provide a horizontal top tube on your bikes to provide an attachment point. I...
    view full answer...